OTHER PRODUCTS USED
White card, 6x6inch card blank, clear glitter, foam tape, hot glue gun
INSTRUCTIONS
Cover a 6x6inch card blank with green paper from the paper pad cut to 5 3/4 inches square, ink edges in green ink, adhere
Cut a purple piece of paper from the paper pad to 5 inches square, ink edges in purple ink, adhere
Die cut four Trellis pieces from the Clematis Birdhouse and Trellis die set, in white card, adhere to the front of the card, overlapping to fit the square
Using Flower Shaping Paper, stamp, colour and die cut the large Trellis, adhere with foam pads
Using Flower Shaping Paper, stamp, colour and die cut the Clematis Birdhouse, adhere to side of Trellis
Stamp, colour and die cut two little birds
Stamp, colour and die cut an assortment of Clematis blooms in various sizes in pink
Stamp, colour and die cut an assortment of Clematis blooms in light green
Stamp, colour and die cut five leaves
Place flowers and leaves in the Flower Shaping Mold, lightly spritz with water, run through a die cutting machine and tap out
When dry, pierce a small hole in the centre of the blooms and thread through some Rock Candy Stamens, use hot glue to secure
When dry, cut off the excess threads, adhere around the card with hot glue
Die cut the shield shape sentiment ticket, stamp Best Wishes on the front
Die cut the next size sentiment ticket in purple paper, adhere the two together and ink the edges in purple
Start adding the flowers and leaves around the card using hot glue
Adhere the two birds
Adhere the sentiment ticket with foam pads
All done.
HERES HOW - Amended
For the base - cut card to 8 1/4 x 7 1/4 inches
Score at 1 inch on three sides, Do not score on the 8 1/4 inch top edge
Die cut the top, using the edge die on the 8 1/4 inch, unscored side of the box
Cut slits in the bottom for the tabs, one on either side, cut out small wedge pieces from the tabs so they glue together well
Apply glue to the top of the two tabs, bring the bottom layer up and glue together, hold in place with pegs or bull dog clips until dry.
For the Flap Front
Cut card stock to 8 1/4 x 11 3/4
(or the length of an 4 sheet of card)
Score at 1 inch on three sides
Score at 7 1/4 and 8 1/4 for the top flap edge (the longest side)
To die cut the shaped flap; See photo 1
Tape the shaped edge die to the top of the flap edge, the unscored edge, fold the sides in and run through a die cutting machine, if you have a large die cutting machine you wont need to fold in the sides
Cut off any excess
Cut slits in the top and bottom to make tabs, cut out a small wedge piece from the tabs so that they glue together well, add wet glue to the top of the base tabs, bring the base and tabs together, add pegs or clips until the glue dries
Fold the two top tabs in and glue down
Slot the two parts together, one inside the other, adhere with wet glue
When dry, decorate with papers from the paper pad, ink the edges, add a flower, leaves and little birds to the flap.
All done.
xxx
I will try and do a photo step by step for the box soon.
xxx
VIDEO HERE
Many thanks for visiting me today, come back soon for lots more inspiration.
GOOD LUCK EVERYONE
Bye for now
xxx